Sundance / Jacuzzi heater - 6500-062
This 2.7 kW heater is manufactured by Balboa and replaces a similar model from Therm Core / Therm Products. It is installed on several models of hot tub manufactured by Sundance Spas and Jacuzzi.
- Jacuzzi : J-310, J-315 and J-325 in 2004 and since 2008
- Sundance Spas : Dover since 2008, Metro and Solo in 2007, Caprio, Metro, and Solo in 2006, 850E in 2005, Lagunas 2003-2005, Portofino 1998-2004
Some older versions of this heater have a built-in pressure switch, and a little control cable that connects to the motherboard of the hot tub control system, to tell the system that there is water flowing through the heater. If you are replacing a heater of this type, you should plug in a jumper, in place of the pressure switch cable, on the motherboard.
We also recommend that you install a flow switch at the exit of this heater, even if the old heater that you are replacing uses a pressure switch to detect the water flow.
You can, however, install a pressure switch if you really insist. You just need to remove a little plug on the heater beforehand, using allen key. Don't forget to use Teflon tape when installing the pressure switch!
Dimensions
Length of long arm: 675 mm
Length of short arm: 455 mm
Width: 175 mm
Distance between tube centres: 90 mm
Cable length: 100 cm
Technical specifications
Power: 2.7 kW
Voltage: 220-240V 50Hz
Current: 11.3A
Operating pressure: 1,1 bar
Warranty
2-year Tubs Parts warranty
Part numbers
Balboa: 58374
Sundance Spas and Jacuzzi: 6500-062
Therm Products : C3226-2A
